Methylohalobius crimeensis
BAA-967 ™
- Product category
-
Bacteria
- Product type
-
Extremophile
- Strain designation
- 10Ki [DSM 16011]
- Type strain
- Yes
- Isolation source
- Saltwater sediment
- Geographical isolation
- Ukraine; Krasnoperekopsk
- Product format
- Freeze-dried
Documentation
ATCC determines the biosafety level of a material based on our risk assessment as guided by the current edition of Biosafety in Microbiological and Biomedical Laboratories (BMBL), U.S. Department of Health and Human Services. It is your responsibility to understand the hazards associated with the material per your organization’s policies and procedures as well as any other applicable regulations as enforced by your local or national agencies.
ATCC highly recommends that appropriate personal protective equipment is always used when handling vials. For cultures that require storage in liquid nitrogen, it is important to note that some vials may leak when submersed in liquid nitrogen and will slowly fill with liquid nitrogen. Upon thawing, the conversion of the liquid nitrogen back to its gas phase may result in the vial exploding or blowing off its cap with dangerous force creating flying debris. Unless necessary, ATCC recommends that these cultures be stored in the vapor phase of liquid nitrogen rather than submersed in liquid nitrogen.
Detailed product information
General
- Preceptrol
- No
Characteristics
- Extremophile type
-
HalophileMethylotroph
Handling information
- Handling procedure
-
1. Open vial according to enclosed instructions.
2. Using a single tube of broth (5 to 6 ml), aseptically withdraw 0.5 ml and use to rehydrate the entire pellet
3. Aseptically transfer this aliquot back to the broth tube and mix well. Transfer 0.1 ml to slants and 0.5 ml to a second tube of #2602 broth. Plate the rehydrated culture (0.1 ml) onto a non-selective medium (to test for purity).
4. The culture should be incubated under a gas mixture of 78% air, 20% methane and 2% CO2. Incubate the culture at 30oC for 48 to 72 hours. The culture needs to be fed a mixture of 78% air, 20% methane and 2% CO2 every 24 to 48 hours. Incubate with shaking to increase growth rate.
- Handling notes
-
Growth should be detected within 3 to 5 days. No growth should occur on the non-selective plates.
The growth rate is increased by shaking the culture while it is incubating. No growth is obtained when CO2 is excluded from the gas mixture.
Methanol (0.4%) can be substituted for the gas mixture, adding 2% CO2 may enhance growth.
Additional information on this culture is available on the ATCC web site at www.atcc.org.
History
- Deposited as
- Methylohalobius crimeensis
- Depositors
- P Dunfield, J Heyer
- Type of isolate
- Environmental
- Year of origin
- 1990
- Special collection
-
NSF - Bacteriology
- Cross references
-
GenBank AJ581837 Methylohalobium crimeensis partial 16S rRNA gene, strain 10Ki.GenBank AJ581836 Methylohalobium crimeensis partial pmoA gene for particulate methane monooxygenase subunit, strain 10Ki.
Legal disclaimers
- Intended use
- This product is intended for laboratory research use only. It is not intended for any animal or human therapeutic use, any human or animal consumption, or any diagnostic use.
- Warranty
-
The product is provided 'AS IS' and the viability of ATCC® products is warranted for 30 days from the date of shipment, provided that the customer has stored and handled the product according to the information included on the product information sheet, website, and Certificate of Analysis. For living cultures, ATCC lists the media formulation and reagents that have been found to be effective for the product. While other unspecified media and reagents may also produce satisfactory results, a change in the ATCC and/or depositor-recommended protocols may affect the recovery, growth, and/or function of the product. If an alternative medium formulation or reagent is used, the ATCC warranty for viability is no longer valid. Except as expressly set forth herein, no other warranties of any kind are provided, express or implied, including, but not limited to, any implied warranties of merchantability, fitness for a particular purpose, manufacture according to cGMP standards, typicality, safety, accuracy, and/or noninfringement.
- Disclaimers
-
This product is intended for laboratory research use only. It is not intended for any animal or human therapeutic use, any human or animal consumption, or any diagnostic use. Any proposed commercial use is prohibited without a license from ATCC.
While ATCC uses reasonable efforts to include accurate and up-to-date information on this product sheet, ATCC makes no warranties or representations as to its accuracy. Citations from scientific literature and patents are provided for informational purposes only. ATCC does not warrant that such information has been confirmed to be accurate or complete and the customer bears the sole responsibility of confirming the accuracy and completeness of any such information.
This product is sent on the condition that the customer is responsible for and assumes all risk and responsibility in connection with the receipt, handling, storage, disposal, and use of the ATCC product including without limitation taking all appropriate safety and handling precautions to minimize health or environmental risk. As a condition of receiving the material, the customer agrees that any activity undertaken with the ATCC product and any progeny or modifications will be conducted in compliance with all applicable laws, regulations, and guidelines. This product is provided 'AS IS' with no representations or warranties whatsoever except as expressly set forth herein and in no event shall ATCC, its parents, subsidiaries, directors, officers, agents, employees, assigns, successors, and affiliates be liable for indirect, special, incidental, or consequential damages of any kind in connection with or arising out of the customer's use of the product. While reasonable effort is made to ensure authenticity and reliability of materials on deposit, ATCC is not liable for damages arising from the misidentification or misrepresentation of such materials.
Please see the material transfer agreement (MTA) for further details regarding the use of this product. The MTA is available at www.atcc.org.
Permits & Restrictions
Import Permit for the State of Hawaii
If shipping to the U.S. state of Hawaii, you must provide either an import permit or documentation stating that an import permit is not required. We cannot ship this item until we receive this documentation. Contact the Hawaii Department of Agriculture (HDOA), Plant Industry Division, Plant Quarantine Branch to determine if an import permit is required.
Frequently Asked Questions
References
Curated Citations
surface sediments from shallow, hypersaline Lake Kirleutskoe, near the town of Krasnoperekopsk, Crimean peninsula, Ukraine
Peter Dunfield, personal communication
Powered by Bioz
Need assistance with this product? Contact our Technical Support team.
Telephone
US and Puerto Rico
800-638-6597
Outside the US
+1-703-365-2700
Hours of Operation
Monday-Friday
9:00am - 5:00pm
US Eastern Time
US Eastern Time
